Page 1 of 1
24v engine electrics
Posted: Fri Jun 04, 2010 12:01 pm
by Ian P
Question 2 is regarding the oil pressure and temperature guage, please can you explain what needs to be done to modify these. thanks
Posted: Fri Jun 04, 2010 12:17 pm
by Ian P
sorry, the rev counter, not the temp gague, presumably the temp sender for the 2.8 can be used.
Posted: Sat Jun 19, 2010 10:31 am
by csr
Swap the temp sender to the one that goes with the guage.
You will need a late 2.8 rev counter - one with a white base.
There is a green wire from the EDIS module for the rev counter.
Connect where the green coil- wire went.
Oil guage - swap the fitting off the 2.8 engine.
As simple as it sounds.
Posted: Sun Jun 20, 2010 7:10 pm
by Ian P
Thanks, much appreciated.