General Chat About Engine Build

Moderators: phpBB2 - Administrators, Moderators

Post Reply
Posts: 1
Joined: Wed Jun 23, 2010 7:56 pm


Post by shazzam »

hi all, newbie on here. looking for some advice. i have a 24v granada and im looking at a manual conversion. (something i think a few of you guys may have done) trouble is im looking at a gearbox off a left hand drive car so the clutch release arm and cable mountings are on the other side of the bell housing?? is this a problem that can be overcome or is it a waste of time buying the box??

any help would be greatly recieved.
thanks all

Forum Sponsor
Forum Sponsor
Posts: 273
Joined: Wed Jan 24, 2007 8:47 pm

Post by csr »

What it means is what you save buying a European MT75 will be spent
getting the clutch cable sorted. And they don't last for ever.

If the box is cheap enough - try to get a UK 4x4 front case for it.
Then the stock 2.8 cable fits fine.
Just some of what we do

Post Reply